Improve the performance of the brake system with constant Brake Overhauling
A good brake system is the most essential component of safe driving. The foundation of a full brake job begins by thoroughly examining the entire brake system. Brake overhauling work is mandatory for all cars as it will not only show the present condition of brakes but will also help to repair brake faults if any.
At PAB Auto Maintenance we ensure a complete brake job looking to all the constituents concerning brake overhauling like:
Although Brake overhauling does not need much work, but if required it should be done to improve safety, prolong the like of the brakes enhancing the brake’s performance.
The first step is a thorough inspection of the brake system that includes the antilock brake system too. This can be done in several ways
Several brands and grades of replacement brake pads can be got. It is recommended to use premium pads like ceramic or non-metallic for vehicles where noise, wear & tear, overuse or high temperature application is the problem. It is advised to replace with the same or better brake pads, like an NAO brake pad should be replaced with an NAO or with an upgraded ceramic or non-metallic one.
If there is a sign of a leaking oil or brake fluid from the caliper then it has to be replaced or rebuilt before you install new brake pads.
In case there are scratches or grooves on the rotor it will need resurfacing or replacement. The general rule is that rotors should have less than .003 and more than.0015 inches of runout. The next step is to check the calipers and caliper mounts. Next is the inspection of the drum surface, wheel cylinder, brake shoes and other hardware.
Brake overhauling includes new hardware. When brake shoes are replaced attention should be paid to other hardware like return springs and wheel bearings. Ensure that shoe support pads on drum backing plates and the parking brake system are lubricated with brake lubricants.
Complete brake job includes bleeding or fresh brake fluid. The brake fluid over time tends to absorb moisture due to which its boiling point is lowered leading to internal corrosion. The fluid should be changed every two years for preventive maintenance.
Brake overhauling also helps to reduce any noise due to vibrations. This could be because of excessive runout of the rotors, loose pads, glazed linings or worn, rusted or loose caliper mounts.
Once the brake repairs are complete, the brake pedal is pumped repeatedly to test the firmness of the pedal before you drive the vehicle. A test drive at slow speed is necessary to see that the brakes are working fine.